# RRDTune

When we create rrd files for ports, we currently do so with a max
value of 12500000000 (100G). Because of this if a device sends us bad
data back then it can appear as though a 100M port is doing 40G+ which
is impossible. To counter this you can enable the rrdtool tune option
which will fix the max value to the interfaces physical speed (minimum
of 10M).

To enable this you can do so in three ways!

- Globally under Global Settings -> Poller -> Datastore: RRDTool
- For the actual device, Edit Device -> Misc
- For each port, Edit Device -> Port Settings

Now when a port interface speed changes (this can happen because of a
physical change or just because the device has misreported) the max
value is set. If you don't want to wait until a port speed changes
then you can run the included script:

`lnms port:tune <hostname> <ifName>` 

Wildcards are supported using * and ifName is optional, i.e:

`lnms port:tune local* eth*`

This script will then perform the rrdtool tune on each port found
using the provided ifSpeed for that port.

Run `lnms port:tune -h` to see help page.